This article gives installation instructions for your LNE45DDB and LNE45DDW 4MP IP PoE Wired Turret Cameras.

What is included:

• 4MP IP PoE Wired Turret Camera
• Mounting Bracket
• Mounting Template
• Anchors & Screws (4Ã )
• Weather-resistant Cap

Camera Placement Tips:

• Consider what you want to monitor and find the best area for coverage.
• Place the camera close to the area of interest.
• Avoid placing the camera directly in front of obstructions like trees, bricks, rain gutters, or reflective surfaces.
• Install the camera where it is difficult for thieves and vandals to reach.
• Ensure the mounting surface can support at least 3.18 lbs/1.44 kg (3Ã the camera's weight).
• The ideal position is about 10 feet/3 meters above ground, angled 15Ã ° downward.
• Secure the cables so they cannot be seen or easily cut.

Installation:

Warning! Ensure the mounting surface supports 3.18 lbs/1.4 kg, 3Ã the camera's weight.

1. Use the mounting template to mark and drill holes for screws and the camera's cable.

Note: To route cables along a wall, use the camera's cable notch. Remove the outlined piece around the notch with pliers.

2. Insert anchors for surfaces like drywall, wood, brick, masonry, or concrete.
3. Attach the mounting bracket to the surface using the provided screws and a screwdriver. Align the â FRONTâ labels on both the bracket and template.

4. Guide the camera's cable through the surface opening or cable notch.
5. Connect one end of the Ethernet cable into the camera's Ethernet connector and the other end into the NVR's PoE port.

6. Secure the weather-resistant cap by twisting it onto the camera's Ethernet connector. If exposed to rain, seal it with silicone or electrical tape.

7. Attach the camera to the bracket by aligning the tabs with the slots. Ensure the â PUSHâ tab on the bracket sticks out from the camera's release slot. Slide the camera forward until it securely "clicksâ into place.

Note: To detach the camera from the bracket, grip the camera firmly and push the â PUSHâ tab.

8. Loosen the adjustment screw with a screwdriver to position the camera, then securely tighten it in place.

9. Important! Remove the vinyl film from the camera lens for a clear view.